The Klein Tools 77000 lifts and holds up to 350 lb across a 10 inch range and weighs 4.06 lb, against 340 lbs, 8-3/4 in and 7 lbs for the DEWALT DWHT83550 it is most often compared with. On November 14, the Klein was $89.98 at Ace Tool and ToolUp, and the DEWALT was $87.95 USD on sale at Toolnut, so price no longer decides between them.

What is the Klein 77000 and when did it come out?

It is a foot operated jack that lifts heavy, awkward material into place and holds it while you fasten it. Klein lists drywall, panels and cabinets as typical loads. Power Tool Insider reported Klein’s entry into the category on May 13, 2026, so the 77000 has been on sale for about six months and is no longer a new launch.

A squeeze handle raises the load, a separate lever lowers it in small steps, and a full release position resets the bar quickly when nothing is on it. Klein includes two removable footplate covers, which it describes as non-marring and anti-slip.

Klein 77000 jack at two heights showing the 10 inch lift range and 350 lb rating
Photo: Klein Tools

How does it compare with the DEWALT DWHT83550?

The table uses Klein’s product page for the 77000, and DEWALT’s figures as published by Toolnut and Pro Tool Reviews for the DWHT83550.

Klein 77000 DEWALT DWHT83550
Load capacity 350 lb 340 lbs
Lift range 10 in 8-3/4 in maximum
Weight 4.06 lb 7 lbs
Overall height 18.5 in not checked
Clamping mode yes, footplate removed not listed
Warranty not stated on product page limited lifetime

The sources do not fully agree. Power Tool Insider wrote that Klein matches DEWALT on a 350 lb capacity and 10 inch lift, but DEWALT’s own figures, as Toolnut and Pro Tool Reviews publish them, are 340 lbs and 8-3/4 in. On those maker numbers, the Klein lifts 1-1/4 in higher and weighs about 3 lb less.

Pro Tool Reviews notes that the DEWALT can be worked by squeezing the handle or stepping on it, and that its tapered base slides under material. That review reports DEWALT’s specs and contains no hands-on test results.

Klein 77000 jack operated by a boot while holding an air conditioner unit
Photo: Klein Tools

What does the clamping mode do?

According to Power Tool Insider, the Klein’s footplate is removable and reversible: take it off and fit it to the top of the bar, and the jack works as a clamp. Klein’s page confirms the clamping configuration but gives no clamping force or maximum opening.

That is the one feature the DEWALT does not list. It matters if you also glue up panels or hold boards against a bench, and not at all if you only hang drywall.

How much do they cost?

Prices moved a lot in November. On November 14, ToolUp listed the Klein at $89.98, down from $134.98, Ace Tool also showed $89.98 USD, and Acme Tools listed $134.98. A Slickdeals post on November 8 reported a lower Lowe’s price that Torque Digest could not confirm on Lowe’s own page.

For the DEWALT, Toolnut showed $87.95 USD on November 14, down from $129.00, and in stock. Pro Tool Reviews gives $119 as its price. All of these are US retailers, and Klein does not publish a list price.

If your work needs two jacks, for example to hang a door or level a run of cabinets, double these figures.

Klein 77000 jack showing the lift, lower and full release levers
Photo: Klein Tools

What should you watch for?

Treat the rating as a ceiling. Neither product page describes these jacks as supports for a person or a vehicle, so read the manual’s limits before the first lift, and keep the jack square to the work on a firm floor.

Buyer discussion of the Klein centres on its plastic parts and how smoothly it lowers compared with the DEWALT, so look at the lowering lever in a store if you can. Klein’s page links to a general warranty page rather than stating terms for the 77000, and ToolUp lists China as the country of origin.

What is still unknown: Klein has not published a clamping force, a minimum height or a 77000 specific warranty.

DEWALT TOUGHSERIES DWHT83550 jack holding drywall on a job site
Photo: DEWALT

Who it suits

  • Drywall and cabinet installer: the 10 inch lift and 350 lb rating cover sheet and carcass work, and 4.06 lb is easy to carry between rooms. Check the warranty terms with Klein before you buy several.
  • Serious DIYer: one jack makes solo drywall and door hanging far easier, and the Klein’s clamp mode adds a bench use. Buy two if you plan to level cabinets.
  • Budget buyer: at about $88 to $90 in mid November, either jack costs about the same. Choose the DEWALT for its published lifetime warranty, or the Klein for lift and weight.
  • Crew already using the DEWALT: the longer lift and clamping mode are useful, but the DEWALT’s published lifetime warranty is the firmer promise. Stay with DEWALT unless the extra reach or clamping matters.
  • Woodworker or shop user: the clamping mode is the reason to pick the Klein. Check its opening and grip on Klein’s page or in person, since no clamping figures are published.

What should you check next?

Compare the Klein 77000 and DEWALT DWHT83550 prices at two or three stores on the day you buy, since both were showing discounts of $40 or more from their regular prices in mid November. Then read each maker’s manual for load limits before the first lift.