If you already own M18, 20V MAX or Makita 12V CXT batteries, the right cordless tire inflator is probably the one that fits them. The Milwaukee M18 2848-20, DEWALT DCC020IB and Makita MP100DZ are all sold as bare tools, and they differ most in size, power options and how much pressure they are built for.
None of the three is new. Construction Junkie reported the DEWALT as released in late 2018, Makita launched its CXT inflator in June 2019 according to Landscape & Amenity, and ToolGuyd gave the Milwaukee an April 2022 ETA. This is a buying guide for the cold months, when tire pressure drops, not news.
How do the three inflators compare on paper?
The table below draws on each maker’s product page, plus ToolGuyd and Construction Junkie for the figures the maker pages leave out.
| Milwaukee 2848-20 | DEWALT DCC020IB | Makita MP100DZ | |
|---|---|---|---|
| Battery | M18 | 20V MAX | 12V max CXT |
| Max pressure | 150 PSI | 160 PSI (Construction Junkie, ToolGuyd) | 120 PSI |
| Other power | None | 12V DC, 110V AC (adapter sold separately) | None |
| Hose | 36 in., brass Schrader chuck | High pressure hose plus high volume hose | 25-1/2 in. |
| Presets | 4 memory slots | Auto shutoff at set pressure | Auto-stop at preset |
| Size or weight | 7 lbs bare, 13.8 x 6.4 x 7.8 in. (ToolGuyd) | Not listed | 9-1/4 x 2-15/16 x 6-13/16 in. (Makita), 2.13 lb (Bob Vila) |
| Warranty | 5 years | 3 years limited, 1 year free service | 3 years limited |
DEWALT’s current page no longer states a maximum pressure, so the 160 PSI figure comes from the trade reports. Makita’s page gives only a 2.78 lb shipping weight, so Bob Vila’s 2.13 lb figure is the closer guide to the tool itself.

Which one fills fastest?
The sources point to different answers. Milwaukee says the 2848-20 tops off a 33 inch light truck tire in under a minute, and ToolGuyd added the fuller claim: 75 to 80 PSI in under a minute and 64 to 80 PSI in a little over 3 minutes. ToolGuyd also lists 1.41 SCFM at 0 PSI and a 33% duty cycle at 80 PSI, so it is built for topping off, not filling from flat repeatedly.
Bob Vila, which tested all three, said the Makita filled the fastest in its group and that its gauge read within 1 PSI of the vehicle’s tire pressure monitor. It gave no fill times for any of them, so treat that as a ranking within one test rather than a number to compare.
What are the trade offs?
Bob Vila picked the DEWALT as best overall and called it relatively quiet, but found that a tall 6Ah battery lifted it off its rubber feet so it bounced and chattered. If you own a smaller 20V MAX pack, that is the one to use with it. Construction Junkie noted the DEWALT’s LED is too dim to use as a flashlight.
The Milwaukee was the loudest inflator on Bob Vila’s list and, in its words, pretty large in weight and size. It also moves so much air that you need to dial it down for bike tires. In return you get the longest hose, four presets and TrueFill, which waits for pressure to settle, checks it and keeps filling until it reaches your target.
Bob Vila kept the Makita out of the top spot because its on-board hose and accessory storage was finicky. Makita also warns it does not work with its older 12V max pod style batteries, only CXT slide packs.

What do they cost?
Launch prices give a sense of scale. ToolGuyd listed the Milwaukee 2848-20 at $169 tool only in 2022, and Construction Junkie gave $99 for the DEWALT bare tool at its 2019 report, with Home Depot then offering a 1.5Ah battery for the same price. On November 14, KMS Tools listed the Makita MP100DZ at CA$79.97 tool only, in select stores. Current prices vary by store and country, so check before you buy.
Add a battery and charger if you own none. Makita lists a 70 minute charge time for its CXT batteries.
Who it suits
- Tradesperson with a van, truck or trailer: buy the one that matches your battery pile. The Milwaukee’s 150 PSI rating, 36 inch hose and presets suit fleet top ups. Check that your tire pressures sit well inside the rating.
- Homeowner who wants one tool for the garage: the DEWALT is the only one that also runs from a car’s 12V socket or, with an adapter, a wall outlet, and it has a high volume hose for air mattresses. Budget for the AC adapter if you want wall power.
- Driver who keeps it in the trunk: the Makita is by far the smallest. Bob Vila found it fast and accurate, but its 120 PSI ceiling and short hose suit cars and bikes more than trucks.
- Cyclist: all three include a Presta adapter. Bob Vila noted the Milwaukee moves so much air that it needs dialing down for bike tires.
- Someone on no battery platform yet: none comes with a battery, so price a starter battery and charger first. Then pick the platform you are most likely to add other tools to.
None of these replaces a shop compressor for seating beads or running air tools.
What should I check before buying?
Confirm which battery and charger you already own, then open the maker pages for the Milwaukee 2848-20, DEWALT DCC020IB and Makita MP100DZ to compare current box contents. Check your tire placard or sidewall for the pressure you need and make sure the inflator’s rating covers it.




